Difference between revisions of "User talk:Larryliang"
Larryliang (talk | contribs) (→Next generation camera body.) |
Larryliang (talk | contribs) (→Next generation camera body.) |
||
| Line 17: | Line 17: | ||
| − | If so, another choice is to change current one-piece body tube to two-half one, jusk like our earlier version. and the lower half can work as an 10353 holder. to keep the cost down, we can make two customized aluminium extrusion, one for lower half , one for uper half. | + | If so, another choice is to change current one-piece body tube to two-half one, jusk like our earlier version. and the lower half can work as an 10353 holder. to keep the cost down, we can make two customized aluminium extrusion, one for lower half , one for uper half. and with such modification, the 10353 board can be little lower, proved more space for adaptor boards ( at least 3 mm). |
Larry. | Larry. | ||
Revision as of 19:49, 27 November 2007
Next generation camera body.
I am thinking of developing of new camera body for 10353+10338 board set ( or future CPU board).
current design can't provide enough space for CPU board holder ( you see, the current version ugly and expensive), and optional CF card adaptor,even the 10349 board.
current inside section of body tube is 35.5mm by 38.5mm, I plan to change it to 44mm by 40mm. and the the outside of camera body should not larger than 50mm by 50 mm.
Any Idea?
Larry,
I was (and still am) trying hard to pack components on the board as compact as I can to keep the camera small. So we can think of rearranging internals (and I am working now on connector placement for USB+SATA+ZIF PATA+2*CF+RS-232+trigger I/O), but it all will use the same overall dimensions. We'll probably have to make cameras some 5 mm longer when motorized sensor focus/tilt will be available.
We may probably simplify internal support by using a custom plastic molded part. --Andrey.filippov 09:46, 27 November 2007 (CST)
If so, another choice is to change current one-piece body tube to two-half one, jusk like our earlier version. and the lower half can work as an 10353 holder. to keep the cost down, we can make two customized aluminium extrusion, one for lower half , one for uper half. and with such modification, the 10353 board can be little lower, proved more space for adaptor boards ( at least 3 mm).
Larry.
