Difference between revisions of "Talk:Ccam.cgi"
| Line 23: | Line 23: | ||
| − | What about rscale, bscale, sens? | + | '' What about rscale, bscale, sens? |
Revision as of 03:06, 21 February 2006
html=2 gets only sensor parameters or FPGA parameters too? For example, it includes P_CLK_FPGA. Is it a FPGA or Sensor parameter?
There is no clear separation between the sensor and the FPGA parameters. I.e. in model 313 sensor driver was taking into account FPGA clock frequency while calculating and setting the "virtual frame height" that limits the frame rate. In the 333 it is currently not needed as the compressor is faster than the sensor in all modes, but the new Micron 5MPix sensor is again twice faster than previous ones - in has 96MHz pixel clock ...
--Andrey.filippov 00:16, 29 September 2005 (MDT)
ww=2048&wh=1536&wl=0&wt=0&dl=4&dh=4&bh=4&bv=4
May be dv (not dl)?
Sure, you are right.--Andrey.filippov 09:54, 12 October 2005 (MDT)
Can I use new decimation's values only with 333 camera or with 313 camera too ? Did change the algorithm of the calculation of values WW, WH, WT and WL after decimation?
--Alexlp 13:42, 16 October 2005 (MDT)
All the decimation values (1-2-3-4-5-6-7-8, not just 1-2-4-8) are available for the Micron MT9T001 3MPix sensor, so it can work with 313 hardware too. *But* - I haven't updated sensor driver for the 313 and these modes are now supported only on the 333 camera.--Andrey.filippov 12:37, 17 October 2005 (MDT)
What about rscale, bscale, sens?
