10334

Discussion on russian

In my board 10332 use this net

1. EXT_SCL	-	MISO
2. EXT_SDA	-	MOSI
3. EXT_RST	-	RESET
4. EXT_CLK	-	XTAL1
5. EXT_EXPOS	-	SCK

Your dauther board is incompatible with too. Ok.

In your shematic we can get high speed 12Mbps USB, but for programming lens control board, need to set jumper. May be use single gate logic from Texace Instrument for generate #RESET for the lens control board combination of nets #OE and Vpo. When #OE set to high level, the USB transiever is shutdown, when Vpo set to high level logic gate generate #RESET for our lens control board. We may use for example SN74AUP1G00 from Texace Instrument.

Master is the CPU board, MOSI (Master Output, Slave Input), but you connect MOSI net to INPUT pin in the CPU. The serial1 pins is not two directional, it is unidirectional, see datasheet of the CPU.

 master			Wensai		CPU 
 out SCK			RXD1		T17 in
 out MOSI			CTS1		V19 in
 in  MISO			TXD1		U19 out
 

I think this connections is correct

   master	CPU	        loop
   out SCK	RTS1 W20 out
   out MOSI	TXD1 U19 out     *
   in MISO	RXD1 T17 in
   

via external single gate element connect out MOSI with in MISO for two-direction 1-Wire protocol and for shutdown the loopback when lens board is programming mode.(SN74AUP1G126).

You can see your shematic with my bugfix follow

shematic from Wensai with bugfix and new features