Zynq development issues
From ElphelWiki
Contents
Config
kernel
4.0 (linux-xlnx 468329e7fac2b22e76897fbd40532cc0884ded2a)
device-tree
...
ps7_usb_0: ps7-usb@e0002000 {
clocks = <&clkc 28>;
compatible = "xlnx,zynq-usb-2.20a", "chipidea,usb2";
reg = <0xe0002000 0x1000>;
interrupt-parent = <&ps7_scugic_0>;
interrupts = <0 21 4>;
dr_mode = "host";
phy_type = "ulpi";
usb-phy = <&usb_phy0>;
} ;
...
} ;
...
usb_phy0: phy0{
compatible = "ulpi-phy";
#phy-cells = <0>;
reg = <0xe0002000 0x1000>;
viewport = <0x170>;
} ;
.config
CONFIG_USB_ULPI=y
CONFIG_USB_ULPI_VIEWPORT=y
CONFIG_USB_CHIPIDEA_DEBUG=y
CONFIG_USB_GPIO_VBUS=n
CONFIG_USB_OTG=n
CONFIG_USB_GADGET=n
from dmesg
[ 1.035759] ehci_hcd: USB 2.0 'Enhanced' Host Controller (EHCI) Driver [ 1.042319] usbcore: registered new interface driver usb-storage [ 1.073619] e0002000.ps7-usb supply vbus not found, using dummy regulator [ 1.103560] Registering platform device 'ci_hdrc.0'. Parent at e0002000.ps7-usb [ 1.114806] ci_hdrc ci_hdrc.0: ChipIdea HDRC found, revision: 22, lpm: 0; cap: f00d4100 op: f00d4140 [ 1.136023] ci_hdrc ci_hdrc.0: unable to init phy: -110 [ 1.141232] ci_hdrc: probe of ci_hdrc.0 failed with error -110
