-
Most parameters are persistent, so if the value is not specified it will be assumed to remain the same.
...name'' ), 0); // read current actual value - driver modifies the set value if needed to match the valid range.
25 KB (3,953 words) - 23:08, 23 February 2008
-
:Not implemented. But it can be added in future if somebody has need in it.
10 KB (1,542 words) - 16:43, 24 August 2008
-
If you will make an image of a fast passing car with ERS with short exposure -
...d instead of nonexistent pixels zero values are fed to the output. But "as if" reading nonexistent pixels in each row (horizontal blanking) and rows of p
6 KB (947 words) - 17:47, 20 October 2016
-
....openstreetmap.org/index.php/JOSM JOSM] but much more interesting would be if the camera could actually point in the direction a photo was taken using a
...o know what frames are interesting and stores them that would be ''nice'', if we can progress with it and actually do ''detection'' and ''classification'
3 KB (561 words) - 04:51, 26 August 2008
-
...es to each block (~100,000). It is a big number for occasional writes, but if some program will write there flushing after each byte written - it will de
...uded in any file system and is not overwritten by the [[flashit]] utility (if "-a" switch is not included). In addition to the bootloader this sector hol
2 KB (368 words) - 16:40, 24 August 2008
-
...FPGA and other hardware and show results -- i.e. get JPEG image and check if the image is "normal". The interface should allow to configure all ktest pa
It seems really simple to implement flashing via USB Flash/HD. If the camera find /autoupgrade.sh script on the USB-flash during the boot it
4 KB (737 words) - 09:27, 19 July 2008
-
...pecial '''hardware inputs''' or just over the '''network'''. In most cases if you want to synchronize 2 or more networked cameras you do not need extra w
2 KB (369 words) - 13:48, 22 September 2008
-
if (camera.ptz) { // if the function is defined
if (XMLHttpRequest) {
3 KB (371 words) - 17:06, 5 December 2005
-
...hel cams when the usb daughter board will be ready. I am volunteer to help if that is of some interest.
624 bytes (112 words) - 09:05, 28 October 2005
-
...s permanently unbootable. The network boot code resides in the CPU ROM, so if flashing fails - you can always start over again.
...and FPGA will fight each other) and overheat fast - just unplug the power if this happens.
3 KB (441 words) - 11:24, 28 November 2007
-
...dual interrupt bits do not change the status of the interrupt requests, so if the interrupt causing event happened while this interrupt was disabled (mas
In responce to the INTA pulse from the CPU (it will be generated if "extrernally generated vector number" is selected) one of the 16 pre-progra
7 KB (1,176 words) - 04:36, 16 December 2005
-
Because now I don't remember if all 4 are actually present on chip.
Because now I don't remember if all 4 are actually present on chip.
12 KB (2,336 words) - 00:13, 7 November 2005
-
;filepos=sec : go to time or percent specifed, maybe not works if mplayer is not support seeking for the current file;
;run=1: to start player again if it was terminated (by error or end of file);
6 KB (1,062 words) - 22:46, 17 April 2007
-
- add some code to recover if the sensor is stuck
2 KB (387 words) - 21:04, 10 April 2007
-
...he it status and frame rate (in percents of the sensor frame rate - to see if any frames are dropped). It also might be as a variable length barm not a n
2 KB (391 words) - 06:43, 17 December 2005
-
...допустимая площадь переэкспонирования], if(K < 0.5)
4 KB (43 words) - 23:24, 23 November 2005
-
If you want to save the stream in separated JPEG-files, it is necessary to use
1 KB (233 words) - 14:36, 23 December 2005
-
If the compilation completes without errors, the executable files mplayer and
972 bytes (150 words) - 07:50, 20 November 2008
-
If you want to obtain the stream with non-specific parameters, a small trick i
...can also play files which are recorded from the MJPG stream. For example, if the stream was saved this way:
2 KB (327 words) - 09:04, 29 December 2005
-
Next, size of output file limited by file system on host. If we can writing files more 2Gb, we will be have limits inside container. It
If file system can't make files with size more 2Gb we can genereate file with
3 KB (536 words) - 12:38, 12 December 2005
