USB FPGA CODE

See discussion also

FPGA code to accomodate USB host module

The code of the JPEG branch of the model 333 camera is modified (in rev 333100e) to accomodate new USB host module currently under development. These modifications also provide vector interrupts (from up to 16 sources) and simplifies the use of 6 FPGA pins connected to the inter-baord connector J2 (and so available at the extension boards).

Vector Interrupts

Axis ETRAX100LX processor [1] supports two modes for external interrupts - with internally generated vector number and with externally generated. In that case CPU generates INTA pulse and the peripheral places an 8-bit vector code on the data bus. New (>=333100e) FPGA code supports both modes, for each of 16 intrerrupts individual vector code can be programmed. Four locations in the FPGA address space (CSP0,CSP4) are writable to control interrupts_vector333 module:

Reset Interrupt Requests

 #define   X313_WA_IRQ_RST   0x1c // reset selected interrupt bits

This register resets the selected bits (having ones in a word written to this location) of the source interrupt request register that is positive edge triggered from asynchronous signal in FPGA and reset by either of two reasons:

• writing to the X313_WA_IRQ_RST (0x1c) register with ones in the bits to be reset and
• servicing thisinterrupt with externally generated vector number. When the INTA is generated the interrupt request bit that caused the interrupt (or at least the one which had it's number placed on data bus in responce to INTA) is reset so software does not need to do it again.

Interrupt MAsk Register

 #define   X313_WA_IRQ_DIS   0x1d // disable selected interrupt bits (mask)
 #define   X313_WA_IRQ_ENA   0x1e // enable selected interrupt bits

These two locations control the interrupt mask register. Ones written to X313_WA_IRQ_DIS disable propagation of the interrupt(s) in the selected bit(s), ones written to X313_WA_IRQ_ENA enable them. After initial FPGA configuration all the interrupts are disabled. Enabling and disabling individual interrupt bits do not change the status of the interrupt requests, so if the interrupt causing event happened while this interrupt was disabled (masked out) and enabled later, the interrupt request to the CPU will be generated.

Interrupt Vector Numbers

#define   X313_WA_IRQ_WVECT 0x1f // write vector number (in bits [0:7], [11:8] - interrupt number (0..15)