User talk:Larryliang

Next generation camera body.

I am thinking of developing of new camera body for 10353+10338 board set ( or future CPU board).

current design can't provide enough space for CPU board holder ( you see, the current version ugly and expensive), and optional CF card adaptor,even the 10349 board.

current inside section of body tube is 35.5mm by 38.5mm, I plan to change it to 44mm by 40mm. and the the outside of camera body should not larger than 50mm by 50 mm.

Any Idea?

Larry,

I was (and still am) trying hard to pack components on the board as compact as I can to keep the camera small. So we can think of rearranging internals (and I am working now on connector placement for USB+SATA+ZIF PATA+2*CF+RS-232+trigger I/O), but it all will use the same overall dimensions. We'll probably have to make cameras some 5 mm longer when motorized sensor focus/tilt will be available.

We may probably simplify internal support by using a custom plastic molded part. --Andrey.filippov 09:46, 27 November 2007 (CST)