Eyesis workflow

Preface

The following page describes the Eyesis camera post-processing procedures.

Camera Output

• 3x 500GB HDDs, each containing *.mov files from 3x 3-sensor cameras (a single HDD is connected to a camera).
• Each frame in a *.mov file is a combination of frames from 3 sensors glued vertically.
• The cameras are numbered - 1,2,3. The sub images are [1.1, 1.2, 1.3], [2.1, 2.2, 2.3], [3.1, 3.2, 3.3]. 3.1 is the fisheye image.
• The frames in *.movs are indexed.
• Single frame format is JP4.
• Corresponding frames have the same time stamps generated by the 1st camera.
• The 1st camera frames are geotagged.

Post-Processing Setup

• HDDs are connected to a processing PC with SATA cables

Workflow

1. Building the Frames Index

• As the frames' index is stored in each corresponding *.mov, it is read and used for building the index of all the frames on 3x drives.

2. Processing Panorama

• By index the 3 corresponding JP4 frames are extracted from HDDs.
• JP4 -> DNG (or openEXR).
• Some Image Processing.
• Each frame is cut on 3 separate subframes - 9 images is the resulting array before stitching.
• Then goes stitching (of JPGs? each individual Eyesis has its constant gluepoints?) and the output is a panorama image.