Trigger 353

Description

10369 board is required.

The triggering is used for one or several cameras synchronization or setting the Frame Rate (or FPS). The conditions of the trigger can be generated either internally or externally. For external triggering a phone cable with RJ14 is used. To program trigger go to: http://192.168.0.9/parsedit.php -> External Trigger Controls

Note!

Be careful with changing parameters when TRIG=4. Camera drivers are driven by the frame sync interrupts from the sensor, so if the sensor is not triggered - everything can get stuck. The Program Ahead value sets the number of frame sync interrupts the camera will wait wait for until a parameter is reprogrammed.

External Trigger Controls page

Parameters

parameter	description
TRIG	Trigger mode enable. Currently 0 - free running, 4 - triggered by external signal or internal FPGA timing generator.
TRIG_PERIOD	FPGA trigger sequencer output sync period (32 bits, in pixel clocks). 0- stop. 1 - single, >=256 repetitive with specified period (values 2..255 are reserved for programming timestamp communication)
TRIG_DELAY	FPGA trigger sequencer trigger delay, 32 bits in pixel clocks
EARLY_TIMESTAMP	When 0 - frame sync (start of the frame readout) will be used for timestamping of the images, when 1 and the trigger mode is external (physically external to the camera or just when sensor runs from the FPGA timing generator) the start of exposure will be used for time stamping (exposure time earlier). This is the default mode to prevent recorded frame period jitter caused by automatic exposure adjustments
TRIG_CONDITION	level) for each GPIO[11:0] pin
TRIG_OUT	level_when_active). Bit 24 - test mode, when GPIO[11:10] are controlled by other internal signals

Examples

Internal

• TRIG_CONDITION=0x0
• set the TRIG_PERIOD
• TRIG=0x4

OR

• set the TRIG_PERIOD
• http://192.168.0.9/sync.php?role=detect&channel=internal

External

Receive: GPIO[10] needs to be configured to receive the trigger signal - set TRIG_CONDITION=0x200000

Generate: GPIO[11] needs to be programmed - set TRIG_OUT=0x800000

Notes:

TRIG_CONDITION: a 22-bit register where 2 bits are used for programming each GPIO (from 0 to 11, e.g., TRIG_CONDITION[1:0] will program GPIO[0]) - MSB enables input and LSB selects active  trigger signal level.

TRIG_OUT: Same as in TRIG_CONDITION register - MSB enables and LSB selects level.

OR

GPIO[11] & GPIO[10] can be set by following http://192.168.0.9/sync.php?role=detect&channel=external

Links

10369 Circuit Diagram, Parts List, PCB layout