Eyesis workflow

From ElphelWiki
Revision as of 17:05, 3 December 2010 by Oleg (talk | contribs)
Jump to: navigation, search

Preface

The following page describes the Eyesis camera post-processing procedures.

Eyesis Output

Fig.1 Eyesis frames
  • 3x HDDs, each containing *.mov files from 3x 3-sensor modules (a single HDD is connected to an individual camera module).
  • Each frame in a *.mov file is a combination of frames from 3 sensors glued vertically - triplet.
  • The modules are numbered - 1,2,3 - having individual ip address:
192.168.0.221 
192.168.0.222
192.168.0.223
  • The sub images are [1.1, 1.2, 1.3], [2.1, 2.2, 2.3], [3.1, 3.2, 3.3]. 3.1 is the fisheye image.
  • The frames in *.movs are indexed.
  • A single image format is JP4 (a raw format with a higher quality and frame rate against *.jpeg).
  • Corresponding frames have the same time stamps generated by the 1st camera.
  • The 1st camera frames are geotagged.

Post-Processing Setup

  • HDDs are put into a processing PC and the data is copied.

Workflow

1. Processing panorama possible solutions

Stitching scripts samples.

  • JP4 images can be extracted and converted to DNGs from *.MOVs by the program movie2dng.
  • Dcraw and the Hugin tools can be used for stitching (a template *.pto for it should be created once).