Ezynq project is started to create a bootloader for systems based on the Xilinx Zynq SoC without the inconvenience of the non-free tools and/or files. The goal is not just to "free" the code, but to provide users with the higher degree of flexibility in fine-tuning of the configuration parameters.
- boot.bin (SPL) - loads u-boot.img, no FSBL needed.
- u-boot.img (u-boot image)
Install meta-toolchain (Kubuntu 13.04)
sudo apt-get install texinfo chrpath git clone -b dylan git://git.yoctoproject.org/poky cd poky . ./oe-init-build-env bitbake meta-toolchain
- Run installation script in build/tmp/deploy/
Install ezynq (Kubuntu 13.04)
git clone git://git.code.sf.net/p/elphel/ezynq ezynq cd ezynq ./install_uboot.sh
- Edit initenv according to the built meta-toolchain
cd u-boot-xlnx ./makeuboot <target>
./makeuboot zynq_microzed_config ./makeuboot zynq_zc706_config ./makeuboot elphel393_config ./makeuboot zynq_zed_config
- The generated files are:
- boot.bin - the SPL image
- u-boot.img - u-boot image (if boot.bin built with SPL support)
- u-boot.html - configuration settings overview
- u-boot.map - the bootloader's memory map
- u-boot - ELF file
- Copy boot.bin & u-boot.img (if generated) to SD card. Boot from it.
Develop (add boards support)
- Add a new board record to the list in the boards.cfg (or leave as is if the item already exists).
- Create a configuration file for the new board - use include/configs/zynq_microzed.h as a reference
- Edit (or create new for specific memory and chip) according to the board configuration the following files:
include/configs/ezynq/ezynq_MT41K256M16RE125.h include/configs/ezynq/ezynq_XC7Z010_1CLG400.h include/configs/ezynq/zed_ezynq.h
IMPORTANT: Only 192KB of zynq's series on-chip memory are available at boot. It is the maximal size of u-boot.bin (not the final boot.bin) - the python script will throw just a warning.
- [FIXED] (in Linux) USB does not work yet.
- [FIXED] (in Linux) Ethernet is not tested (on the board we have it does not work with provided images, so we suspect a hardware problem. If no network:
ifconfig eth0 down ifconfig eth0 up
- Bitstream loading is not tested, current code does not enable level shifters - it may be more appropriate to do just before loading of the bitstream.
- Write level training for DDR memory doesn't work in MicroZed and ZC706