Difference between revisions of "Load custom bitstream"
From ElphelWiki
| Line 8: | Line 8: | ||
* ''/usr/local/verilog/'' | * ''/usr/local/verilog/'' | ||
| + | Init: | ||
| + | * /etc/init.d/init_elphel393 | ||
| + | ... | ||
| + | $CONFDIR/init_elphel393.py "{\"usb_hub\":1, \"ip\":1,\"imgsrv\":1, \"autoexp_daemon\":1, \"autocampars\":1, \"sata\":1, \"gps\":1, \"eyesis\":0 }" | ||
| + | ... | ||
| + | ** in this line the extra init procedures are listed, to disable/skip certain procedure set 0, to enable - set 1 | ||
| + | ** everything is done in ''/etc/elphel393/init_elphel393.py'' which runs other scripts. | ||
| + | ** the bitstream is loaded by '''autocampars''' and (if '''autocampars''' is skipped) '''sata''' | ||
[[Category:393]] | [[Category:393]] | ||
Revision as of 13:57, 20 April 2017
Description
The default bitstream is loaded from OS not from u-boot. Reasons:
- Different banks have different (software - controlled and regulated) voltages and they need to be set up before loading.
- voltages are set by the software through i2c
Bitstreams paths:
- /usr/local/verilog/
Init:
- /etc/init.d/init_elphel393
...
$CONFDIR/init_elphel393.py "{\"usb_hub\":1, \"ip\":1,\"imgsrv\":1, \"autoexp_daemon\":1, \"autocampars\":1, \"sata\":1, \"gps\":1, \"eyesis\":0 }"
...
- in this line the extra init procedures are listed, to disable/skip certain procedure set 0, to enable - set 1
- everything is done in /etc/elphel393/init_elphel393.py which runs other scripts.
- the bitstream is loaded by autocampars and (if autocampars is skipped) sata
