Difference between revisions of "10393 power"
From ElphelWiki
(→3.3V) |
(→3.3V) |
||
| (2 intermediate revisions by the same user not shown) | |||
| Line 21: | Line 21: | ||
==3.3V== | ==3.3V== | ||
| + | * Without power board | ||
{| | {| | ||
| − | |valign='top'|[[File:10393 power33 1.jpeg|thumb|320px|Fig.3 10393 and cable, see [[10393|schematics]]]] | + | |valign='top'|[[File:10393 power33 1.jpeg|thumb|320px|Fig.3 10393 (J1) and cable, see [[10393|schematics]]]] |
| − | |valign='top'|[[File:10393 power33 | + | |valign='top'|[[File:10393 power33 2b.jpeg|thumb|320px|Fig.4 Any side can be used]] |
|valign='top'|[[File:10393 power33 3.jpeg|thumb|320px|Fig.5 Power supply]] | |valign='top'|[[File:10393 power33 3.jpeg|thumb|320px|Fig.5 Power supply]] | ||
|} | |} | ||
[[Category:393]] | [[Category:393]] | ||
Revision as of 12:07, 4 January 2018
18-75V (48V)
- camera's DC-DC converter installed: TRACO POWER THD 12-4810WI, IN 18-75V, OUT 3.3V/3500mA
Notes
- For 48V the recommended connector is J3 (accessible from the back panel)
9-36V (12V)
- camera's DC-DC converter installed: TRACO POWER THD 12-2410WI, IN 9-36V, OUT 3.3V/3500mA
Notes
- For 12V the recommended connector is J4 - bypassing diodes reduces voltage drop and the chances of not hitting the lower voltage limit are higher.
- For 18+ V the recommended connector is J3
Power supply requirements
AC/DC WALL MOUNT ADAPTER
- 20+ W
- 48V => 0.42+ A
- 12V => 1.67+ A
3.3V
- Without power board
 Fig.3 10393 (J1) and cable, see schematics |
