Eyesis assembly: Difference between revisions
Jump to navigation
Jump to search
No edit summary |
No edit summary |
||
| Line 1: | Line 1: | ||
== Head == | == Head == | ||
=== Step 1: Front Ends === | === Step 1: Head + Front Ends (already assembled and focused)<br> === | ||
{| | {| | ||
| Line 9: | Line 9: | ||
|} | |} | ||
*Connect cables to the Front Ends. | |||
*Put the front ends one by one into the head. | |||
=== Step | === Step 2: Head + Boards === | ||
*See Fig.1. There are 3 holes in the disk attached to the head bottom. The 1st hole is on the above of one of the 'eyes' and others are not - so it's easy to find it. | *See Fig.1. There are 3 holes in the disk attached to the head bottom. The 1st hole is on the above of one of the 'eyes' and others are not - so it's easy to find it. | ||
| Line 39: | Line 38: | ||
|} | |} | ||
== Box == | == Box == | ||
{a schematic picture + photo}<br> | |||
== Eyesis == | == Eyesis == | ||
#Put a "cup" on the pole. | #Put a "cup" on the pole. | ||
#Connect the corresponding cables from the box (coming out of the pole) to the head {add a photo with comments} | #Connect the corresponding cables from the box (coming out of the pole) to the head {add a photo with comments} | ||
#Attach the head to the cup. | #Attach the head to the cup. | ||
#Choose the head orientation and tighten the "cup"'s 2 big screws. | #Choose the head orientation and tighten the "cup"'s 2 big screws. | ||
Latest revision as of 02:28, 1 December 2010
Head
Step 1: Head + Front Ends (already assembled and focused)
 |
 |
- Connect cables to the Front Ends.
- Put the front ends one by one into the head.
Step 2: Head + Boards
- See Fig.1. There are 3 holes in the disk attached to the head bottom. The 1st hole is on the above of one of the 'eyes' and others are not - so it's easy to find it.
- See Fig.2. Attach the part with main boards to the head (use thread-locker with these 3 screws). The cables from the marked sensors will go to the closest to the 1st hole board (on Fig.1,2 colors and eyes match)
- Rotate the head counter clockwise (from 'hole 1' to 'hole 2') - attach the next 3 cables.
- Remaining 3 cables go to the board near the 3rd hole.
 |
 |
- Attach sync cables to the 10369 boards:
Notes: * The 1st board is the one near the 1st hole. * J14 - cable foil up * J12, J13 - cable foil down * Better to start connecting with J14 side of the cable.
 |
Box
{a schematic picture + photo}
Eyesis
- Put a "cup" on the pole.
- Connect the corresponding cables from the box (coming out of the pole) to the head {add a photo with comments}
- Attach the head to the cup.
- Choose the head orientation and tighten the "cup"'s 2 big screws.