10359 FPGA Simulation

The main page for the board is 10359.

Verification

1. Channel 3 simulation:

• DDR initialization through i2c - done.
• write to DDR - done.
• read from DDR - done.

2. PHASE_SHIFT in DCM is not available currently, because the model had bad constructs, but SDCLK(SDNCLK) can be controlled by "phsel".

For correct writing/reading from DDR in model set phsel="01" (register=0x1008, value=0x00000004).

          ==Board tests==

1. I2c check

a. It doesn't work when assemled with mcontr and 2 DCMs.
b. Started from the beginning. Works.
c. Checked i2c four read with 1 start. Works fine.
d. Adding DCMs.

2. Check BRAM read/write. All's fine

3. Check DDR read/write. Some problems. not solved

4. Three different boards operate identically: BRAM - ok, DDR - not

       a. not marked 359
          acquired data is 0x05020306
          acquired data is 0x05060706
          acquired data is 0x090a0b16
          acquired data is 0x0d0e1f16
          acquired data is 0x11121316
          acquired data is 0x15161716
          acquired data is 0x191a1b06
          acquired data is 0x1d1e0f26
          acquired data is 0x21222326
          acquired data is 0x25262726
          acquired data is 0x292a2b36
          acquired data is 0x2d2e3f36
          acquired data is 0x31323336
          acquired data is 0x35363736
          acquired data is 0x393a3b26
          acquired data is 0x3d3e2f46

       b. yellow circle marked 359
          acquired data is 0x01020306
          acquired data is 0x05060706
          acquired data is 0x090a0b16
          acquired data is 0x0d0e1f16
          acquired data is 0x11121316
          acquired data is 0x15161716
          acquired data is 0x191a1b06
          acquired data is 0x1d1e0f26
          acquired data is 0x21222326
          acquired data is 0x25262726
          acquired data is 0x292a2b36
          acquired data is 0x2d2e3f36
          acquired data is 0x31323336
          acquired data is 0x35363736
          acquired data is 0x393a3b26
          acquired data is 0x3d3e2f46

Understanding how 353's mcontr works

02/28/08: 15:04 for mode=0 ( 8 - burst length)

TileX - number of (32x8) blocks
Seq_par(or Param) - the last write block length - (Seq_par)x8
TileY - number of TileX
All this starts from StartAddress