Difference between revisions of "Eyesis assembly"
From ElphelWiki
| Line 1: | Line 1: | ||
| − | == Head == | + | == Head == |
| − | === Step 1: Front Ends === | + | === Step 1: Head + Front Ends (already assembled and focused)<br> === |
{| | {| | ||
| Line 9: | Line 9: | ||
|} | |} | ||
| − | + | *Connect cables to the Front Ends. | |
| + | *Put the front ends one by one into the head. | ||
| − | === Step | + | === Step 2: Head + Boards === |
| − | |||
| − | |||
*See Fig.1. There are 3 holes in the disk attached to the head bottom. The 1st hole is on the above of one of the 'eyes' and others are not - so it's easy to find it. | *See Fig.1. There are 3 holes in the disk attached to the head bottom. The 1st hole is on the above of one of the 'eyes' and others are not - so it's easy to find it. | ||
| Line 39: | Line 38: | ||
|} | |} | ||
| − | == Box == | + | == Box == |
| + | |||
| + | {a schematic picture + photo}<br> | ||
| − | == Eyesis == | + | == Eyesis == |
| − | #Put a "cup" on the pole. | + | #Put a "cup" on the pole. |
| − | #Connect the corresponding cables from the box (coming out of the pole) to the head {add a photo with comments} | + | #Connect the corresponding cables from the box (coming out of the pole) to the head {add a photo with comments} |
#Attach the head to the cup. | #Attach the head to the cup. | ||
#Choose the head orientation and tighten the "cup"'s 2 big screws. | #Choose the head orientation and tighten the "cup"'s 2 big screws. | ||
Latest revision as of 18:28, 30 November 2010
Contents
Head
Step 1: Head + Front Ends (already assembled and focused)
- Connect cables to the Front Ends.
- Put the front ends one by one into the head.
Step 2: Head + Boards
- See Fig.1. There are 3 holes in the disk attached to the head bottom. The 1st hole is on the above of one of the 'eyes' and others are not - so it's easy to find it.
- See Fig.2. Attach the part with main boards to the head (use thread-locker with these 3 screws). The cables from the marked sensors will go to the closest to the 1st hole board (on Fig.1,2 colors and eyes match)
- Rotate the head counter clockwise (from 'hole 1' to 'hole 2') - attach the next 3 cables.
- Remaining 3 cables go to the board near the 3rd hole.
- Attach sync cables to the 10369 boards:
Notes: * The 1st board is the one near the 1st hole. * J14 - cable foil up * J12, J13 - cable foil down * Better to start connecting with J14 side of the cable.
Box
{a schematic picture + photo}
Eyesis
- Put a "cup" on the pole.
- Connect the corresponding cables from the box (coming out of the pole) to the head {add a photo with comments}
- Attach the head to the cup.
- Choose the head orientation and tighten the "cup"'s 2 big screws.
