103692

103692 - Adapter board for ZIF-type 1.8" HDD

103692 Circuit Diagram, Parts List, PCB layout     103692 Gerber files

103692 is an adapter board used with the 10369 board to connect ZIF-type 1.8" hard drive to the Elphel Model 353 camera.

Connectors

---

J1 - to 10369 board

connector to the 10369 board

Pin	Signal	Notes		Pin	Signal	Notes
1	CF1PRESENT	GND if CF1 installed		26	GND
2	B0D[11]			27	B0D[3]
3	B0D[12]			28	B0D[4]
4	B0D[13]			29	B0D[5]
5	B0D[14]			30	B0D[6]
6	B0D[15]			31	B0D[7]
7	B0CS1			32	B0CS0
8	--			33	--
9	B0IORD			34	GND
10	B0IOWR			35	--
11	--			36	--
12	B0INTRQ			37	--
13	+3.3V			38	+3.3V
14	GND			39	SCL
15	B0RSTS	Reset master		40	SDA
16	B0RSTM	Reset slave		41	--
17	B0IORDY			42	GND
18	B0DMARQ			43	B0A[2]
19	B0DMACK			44	B0A[1]
20	B0DASP			45	B0A[0]
21	B0PDIAG			46	B0D[0]
22	B0D[8]			47	B0D[1]
23	B0D[9]			48	B0D[2]
24	B0D[10]			49	B0IOCS16
25	GND			50	CF0PRESENT	GND if CF0 installed

---

J2 - IDE (to the HDD)

IDE connector (to the ZIF-type 1.8" HDD)

Pin	Signal	Notes		Pin	Signal	Notes
1	--			2	--
3	B0RSTM			4	GND
5	B0D[7]			6	B0D[8]
7	B0D[6]			8	B0D[9]
9	B0D[5]			10	B0D[10]
11	B0D[4]			12	B0D[11]
13	B0D[3]			14	B0D[12]
15	B0D[2]			16	B0D[13]
17	B0D[1]			18	B0D[14]
19	B0D[0]			20	B0D[15]
21	GND			22	B0DMARQ
23	GND			24	B0IOWR
25	B0IORD			26	GND
27	B0IORDY			28	GND
29	B0DMACK			30	B0INTRQ
31	B0A[1]			32	B0PDIAG
33	B0A[0]			34	B0A[2]
35	B0CS0			36	B0CS1
37	B0DASP			38	+3.3V
39	+3.3V			40	--

Note: This connector uses 0.3mm flex cable, the HDD needs 0.2mm cable end.