Eyesis assembly

Head

Step 1: Front Ends

Step 4: Head + Boards

• See Fig.1. There are 3 holes in the disk attached to the head bottom. The 1st hole is on the above of one of the 'eyes' and others are not - so it's easy to find it.
• See Fig.2. Attach the part with main boards to the head (use thread-locker with these 3 screws). The cables from the marked sensors will go to the closest to the 1st hole board (on Fig.1,2 colors and eyes match)
• Rotate the head counter clockwise (from 'hole 1' to 'hole 2') - attach the next 3 cables.
• Remaining 3 cables go to the board near the 3rd hole.

• Attach sync cables to the 10369 boards:

Notes:
 * The 1st board is the one near the 1st hole.
 * J14 - cable foil up
 * J12, J13 - cable foil down
 * Better to start connecting with J14 side of the cable.

Eyesis

1. Put a "cup" on the pole.
2. Connect the corresponding cables from the box (coming out of the pole) to the head {add a photo with comments}
3. Attach the head to the cup.
4. Choose the head orientation and tighten the "cup"'s 2 big screws.